Kingston ValueRAM 32GB 2666MHz DDR4 CL19 DIMM Single RAM
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP = 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• Nominal and dynamic on-die termination (ODT) for data, strobe, and mask signals
• Low-power auto self refresh (LPASR)
• Data bus inversion (DBI) for data bus
• On-die VREFDQ generation and calibration
• Dual-rank
• On-board I2 serial presence-detect (SPD) EEPROM
• 16 internal banks; 4 groups of 4 banks each
• Fixed burst chop (BC) of 4 and burst length (BL) of 8 via the mode register set (MRS)
• Selectable BC4 or BL8 on-the-fly (OTF)
• Fly-by topology
• Terminated control command and address bus
• PCB: Height 1.23” (31.25mm)
• RoHS Compliant and Halogen-Free
This document describes ValueRAM’s KVR26N19D8/32 is a 4G x
64-bit (32GB) DDR4-2666 CL19 SDRAM (Synchronous DRAM), 2Rx8,
memory module, based on sixteen 2G x 8-bit FBGA components. The
SPD is programmed to JEDEC standard latency DDR4-2666 timing of
19-19-19 at 1.2V. Each 288-pin DIMM uses gold contact fingers. The
electrical and mechanical specifications are as follows:
SPECIFICATIONS
CL(IDD): 19 cycles
Row Cycle Time (tRCmin): 45.75ns(min.)
Refresh to Active/Refresh Command Time (tRFCmin): 350ns(min.)
Row Active Time (tRASmin): 32ns(min.)
Maximum Operating Power: TBD W*
UL Rating: 94 V – 0
Operating Temperature: 0 C to +85 C
Storage Temperature: -55 C to +100 C
*Power will vary depending on the SDRAM used.
Weight | 0.5 kg |
---|
You must be logged in to post a review.
Reviews
There are no reviews yet.